Connect the Wires in Your Kiosk

The diagram below shows the cables and connections required to set up the inside of the Ocean Kiosk (using the peripheral items and tablet that you ordered for the kiosk). A picture of the proper set-up is also attached to this article, for your reference.

Kiosk-Setup-cropped.png

Short cable that comes with the Similcharge connector (microUSB to microUSB)

A Plug one microUSB into the Tablet.

B Plug one microUSB into the Similcharge connection port labeled "Tablet".

Medium length cable that comes with the reader (microUSB to USB)

C Plug the standard USB into the Similcharge connection port labeled with a USB symbol.

D Pull the cable through the mounting plate of the kiosk.

E Plug the microUSB into the reader. This one can be fussy and needs to be fully pushed into the reader.

Long cable (microUSB to USB)

F Plug the microUSB into the Similcharge connection port labeled with a power symbol.

G Run the cord down the stand leg and out the opening by the floor.

H Plug the standard USB into the Samsung charging block. Make sure the Samsung charger is plugged into a working outlet.

Tips When Connecting Your Wires

  • Ensure that you are not putting undue tension on the natural curve of the wire that connects the Simulcharge and the tablet.
  • The microUSB ports on the Simulcharge can become a little loose sometimes, so please make sure that all 3 wires are plugged in snuggly into the Simulcharge.
  • Make sure that there is nothing applying pressure straight down on the Simulcharge board, especially on the top of the microUSB ports.
Have more questions? Submit a request